if the window shown in the figure above () appears, click the start button again. if the window shown in the figure above () appears, attach your calibrator as shown in the figure above and click the proceed button. calibration will start. to exit the program during the calibration, press the ctrl+alt+del keys and click finish.
after completing the calibration, the window shown in the figure below will appear. then remove your calibrator and click the ok button.
the calibrated values will now be shown. verify the values, and click the save button to save the settings.
type in a name for the profile and click the ok button. you will be asked whether to save the calibrated settings to your monitor. to save them, click the ok button. it takes some time to save these settings. the calibrated settings saved on the monitor are saved as the calibration mode which constitutes a part of the color mode of your monitor. from now on, your monitor will use the saved settings whenever calibration mode is selected.
when finished, click the cancel button. when exiting the program after saving the changed settings as the calibration mode, the color mode of your monitor will change to the just saved current calibration mode. if the program is not exited normally because communication to the monitor is disconnected, the “olor calibration” message will appear when pressing the osd. if this occurs, run thed exit it normally.